Upcoming shows/vending:





 Know of a show I should go to? Tell me!

* indicates big show (attendance in the thousands)

Joystick Deadzone / Firmness

Make that joystick feel "just right". Trouble shoot wonky joysticks, dead microswitches and getting to know your arcade controls.

Suzo Happ Actuator

I 3D modeld the actuator for the Suzo Happ joysticks I favor. I actually misplaced this part; it was faster to make it then buy a replacement. The 123D file is below.

Its native size is 24 x 24 x 14.2mm and the shaft hole is oversized to allow PLA shrinkage.

I rescaled [the CAD file] to 22.8 x 22.8 x 14.2mm in Cura for a prefect fit using my PrintrBot Simple Metal. Used 30% infill.


I also lost the E-ring too (I think it's inside the vacuum?), but it's a common part you can find at the hardware store, look for a 5/16" e-ring.


You can make customizations with the raw CAD file below.

Happ Actuator | 8-way Competition Stick
Use with Autodesk 123D
Happ action.rar
Compressed file archive [111.0 KB]
Print Print | Sitemap
© 2013-2016 Ryan Bates and © 2013-2016 Retro Built Games, LLC. All photos, designs, documents, and graphics (C) Ryan Bates. All Rights Reserved.

This site is best viewed on a desktop PC. (Can't find the payment buttons? Use a desktop web browser or Request Desktop Site)